ВходНаше всё Теги codebook 无线电组件 Поиск Опросы Закон Пятница
29 марта
1039720 Топик полностью
fk0, легенда (24.09.2020 14:58, просмотров: 236) ответил LightElf на Ронять - категорически не советую, а резко крутить ничем не поможет - уже много лет головы паркуют за пределами блина, Удар может (хоть и маловероятно) сбросить головы с рампы и тогда совсем диагноз.
Внутри газ, диск нагревается -- давление сильно вырастает. Какая ещё мембрана? Она должна съедать заметный процент от объёма. Фа и зачем -- проще держать под давлением. И работать же должно на высоте 2км, например (в самолёте, в горных районах). Это ж лишние ~20% объёма надо, как и при нагреве. Просто герметичные -- бывают. A с отверстием и вентилируемым объёмом наверное проще, т.к. плохая герметичность может только добавить проблем (давлением распирать будет, может 

насосать воздуха насыщенного водяным паром из атмосферы и потом он сконденсируется в виде луж на дисках и т.п.)


Бывают случаи, когда останавливается на блине (не вовремя выключили). И при включении звенит и раскручивается с пятого раза. Я предполагал "прикипание" голов к блину, потому, что механически там больше нечему ломаться. Конечно тут же вспомнились знаменитые Quantum в которых не вымыли флюс, который съедал какую-то важную микросхему и все они померли на 3-й год...


Процитирую википедию:

The HDD's spindle system relies on air density inside the disk enclosure to support the heads at their proper flying height while the disk rotates. HDDs require a certain range of air densities to operate properly. The connection to the external environment and density occurs through a small hole in the enclosure (about 0.5 mm in breadth), usually with a filter on the inside (the breather filter).[131] If the air density is too low, then there is not enough lift for the flying head, so the head gets too close to the disk, and there is a risk of head crashes and data loss. Specially manufactured sealed and pressurized disks are needed for reliable high-altitude operation, above about 3,000 m (9,800 ft).[132] Modern disks include temperature sensors and adjust their operation to the operating environment. Breather holes can be seen on all disk drives – they usually have a sticker next to them, warning the user not to cover the holes. The air inside the operating drive is constantly moving too, being swept in motion by friction with the spinning platters. This air passes through an internal recirculation (or "recirc") filter to remove any leftover contaminants from manufacture, any particles or chemicals that may have somehow entered the enclosure, and any particles or outgassing generated internally in normal operation. Very high humidity present for extended periods of time can corrode the heads and platters.


[ZX]