Микроконтроллеры

Ни хрена себе пельмень 17.2.3 Voltage Reference Generator The ADC12 module contains a built-in voltage reference with two selectable voltage levels, 1.5 V and 2.5 V. Either of these reference voltages may be used internally and externally on pin VREF+. Setting REFON=1 enables the internal reference. When REF2_5V = 1, the internal reference is 2.5 V, the reference is 1.5 V when REF2_5V = 0. The reference can be turned off to save power when not in use. For proper operation the internal voltage reference generator must be supplied with storage capacitance across VREF+ and AVSS. The recommended storage capacitance is a parallel combination of 10-µF and 0.1-µF capacitors. From turn-on, a maximum of 17 ms must be allowed for the voltage reference generator to bias the recommended storage capacitors. If the internal reference generator is not used for the conversion, the storage capacitors are not required. Note: Reference Decoupling Approximately 200 µA is required from any reference used by the ADC12 while the two LSBs are being resolved during a conversion. A parallel combination of 10-µF and 0.1-µF capacitors is recommended for any reference used. External references may be supplied for VR+ and VR– through pins VeREF+ and VREF–/VeREF– respectively.