rezident (27.10.2011 20:32, просмотров: 156) ответил progchip на Помогите плиз запустить UART LPC1114 Пример из IAR. /*****************************************************************************
** Function name: UARTInit
**
** Descriptions: Initialize UART0 port, setup pin select,
** clock, parity, stop bits, FIFO, etc.
**
** parameters: UART baudrate
** Returned value: None
**
*****************************************************************************/
void UARTInit(uint32_t baudrate)
{
uint32_t Fdiv;
uint32_t regVal;
UARTTxEmpty = 1;
UARTCount = 0;
NVIC_DisableIRQ(UART_IRQn);
LPC_IOCON->PIO1_6 &= ~0x07U; /* UART I/O config */
LPC_IOCON->PIO1_6 |= 0x01; /* UART RXD */
LPC_IOCON->PIO1_7 &= ~0x07U;
LPC_IOCON->PIO1_7 |= 0x01; /* UART TXD */
/* Enable UART clock */
LPC_SYSCON->SYSAHBCLKCTRL |= (1<<12);
LPC_SYSCON->UARTCLKDIV = 0x1; /* divided by 1 */
LPC_UART->LCR = 0x83; /* 8 bits, no Parity, 1 Stop bit */
regVal = LPC_SYSCON->UARTCLKDIV;
Fdiv = ((SystemAHBFrequency/regVal)/16)/baudrate ; /*baud rate */
LPC_UART->DLM = Fdiv / 256;
LPC_UART->DLL = Fdiv % 256;
LPC_UART->LCR = 0x03; /* DLAB = 0 */
LPC_UART->FCR = 0x07; /* Enable and reset TX and RX FIFO. */
/* Read to clear the line status. */
regVal = LPC_UART->LSR;
/* Ensure a clean start, no data in either TX or RX FIFO. */
while ( LPC_UART->LSR & (LSR_THRE|LSR_TEMT) != (LSR_THRE|LSR_TEMT) );
while ( LPC_UART->LSR & LSR_RDR )
{
regVal = LPC_UART->RBR; /* Dump data from RX FIFO */
}
/* Enable the UART Interrupt */
NVIC_EnableIRQ(UART_IRQn);
#if TX_INTERRUPT
LPC_UART->IER = IER_RBR | IER_THRE | IER_RLS; /* Enable UART interrupt */
#else
LPC_UART->IER = IER_RBR | IER_RLS; /* Enable UART interrupt */
#endif
return;
}
-
- Спасибо, пока криминала не нашёл у себя. progchip(153 знак., 27.10.2011 21:06)